Shelly Wave Shutter UL-Certified

Controls position of blinds, rollers, shades, venetian blinds, etc.
Switching output O1 On, motor will start moving blind Up, switching output O2 On, motor will start moving blind Down.

The Device measures energy consumption of the connected motor.

When the blind is stopped by end-switch of the motor (Up or Down extreme position), the Device will recognize this because the measured power consumption will drop to zero or to very low value.

When the blind is stopped by end-switch of the motor (Up or Down extreme position), or by the Device that determines the extreme position (Up or Down) has been reached based on time, the output O1 or O2 must switch Off, even if the switch connected to SW1 or SW2 is active.

Movement time in any direction is limited to max. 2 X Up/Down movement time.

Example.

If movement time for Up is 10s, the motor can’t be supplied for more than 20s!

The Device must never drive the two phases of connected motor at the same time.

That is outputs O1 and O2 must never be active at the same time, even when SW1 and SW2 inputs are active at the same time or Z-Wave command is received that Q1 and Q2 must be active at the same time.
It is recommended to use only blind motors with electronic or mechanical limit switches. The motor limit switches must be set correctly before connecting the Device to the motor.

Shutter - Switch/push-button connected to input terminal SW1 and SW2
Supported Switch/push-button to input terminals SW1 and SW2

· switch with up, down and neutral position

· push-button with up and down poles and with normal position in neutral (no signal)

By default inputs are defined as push-buttons. SW1 and SW2 must defined both as switches or both as push-buttons.

This can be changed by Parameter No. 5.

Switch/push-button directions connected to:

SW1 is used for Up (Open) command, controlling output O1 (Up)

SW2 is used for Down (Close) command, controlling output O2 (Down)

In case both SW1 and SW2 are active at same time, outputs O1 and O2 are switched both OFF.

Push-button SW1 or SW2 - Single press
Single press on push-button is a press that lasts less than 0,5 seconds.

Single press will trigger blind moving in the direction chosen. For the resulting actions see the table at the end of this table.
If blind is moving, any press (of any push-button) will stop the movement.

Push-button SW1 or SW2 - press and hold (long press)
Press and hold on push-button is a press that lasts longer than 0,5 seconds.

Press and hold will trigger moving and tilting the blind in the direction chosen but as soon as the push-button is released, the movement will stop.

The main purpose of this feature is to allow for precise control tilting of venetian blind with push-button.

For the resulting actions see the table at the end of this table.